Instelling voor een cisco router [1111X bijvoorbeeld] met KPN Glasfiber

gebruik interface GigabitEthernet0/0/0 of GigabitEthernet0/0/1, dat is de WAN cq naar de KPN box.
NIET: interface GigabitEthernet0/1/0 , GigabitEthernet0/1/1 , de 8 Ports switch is voor LAN!!

LET OP: L3 GigabitEthernet

Router#configure terminal

Router(config)#default interface GigabitEthernet0/0/0

interface GigabitEthernet0/0/0
mtu 1512
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
no shut
!

interface GigabitEthernet0/0/0.6

exit

default interface GigabitEthernet0/0/0.6

interface GigabitEthernet0/0/0.6

description WAN
encapsulation dot1Q 6
 no ip address
 no ip redirects
 no ip unreachables
 no ip proxy-arp
 pppoe enable group global
 pppoe-client dial-pool-number 1
 pppoe-client ppp-max-payload 1500
 no shut
!

!
interface Dialer1
 ip address negotiated
 no ip redirects
 no ip unreachables
 no ip proxy-arp
 ip nat outside
 ip virtual-reassembly in
 encapsulation ppp
 dialer pool 1
 dialer idle-timeout 0
 dialer-group 1
 no cdp enable
 ipv6 address 2A02:A4XXX:XXXX:0:b19:ba11:c001:b00b/64
 ipv6 enable
 ipv6 nd ra interval 30
 ipv6 verify unicast reverse-path
 ipv6 dhcp client pd hint 2A02:AXXX:XXXX::/48
 ipv6 dhcp client pd mijn-kpn-prefix rapid-commit
 ipv6 mld query-interval 60
 ipv6 virtual-reassembly in
 ppp authentication pap callin
 ppp pap sent-username kpn password 7 07043142
 ppp ipcp dns request
 no shut
!
exit

!

dialer-list 1 protocol ip permit
dialer-list 1 protocol ipv6 permit
!
ip route 0.0.0.0 0.0.0.0 Dialer1
ipv6 route ::/0 Dialer1
!

exit

write